banner



How To Remove Waterpik Head

How To Clean A Shower Head - Top 3 Tips


Is your shower head not performing like it used to? Over time mineral deposits can build up which can cause the nozzles to squirt water in all directions or clog up completely, leaving you with poor water pressure or low flow.

Here are our top tips to help go your shower head back to peak functioning.

#1 Rub the Nozzles

Many shower heads have flexible rubber nozzles. You can dislodge mineral buildup in these nozzles by simply massaging each nozzle with your finger. You can besides endeavor gently scrubbing the nozzles with a toothbrush.

#ii Soak the Shower Head in Vinegar

At that place are a couple ways to exercise this:

  • If y'all prefer to leave the shower head attached to the pipe coming out of the wall, y'all can fill a plastic bag with vinegar and wrap information technology around the shower head.
    • Secure the purse around the head with a prophylactic ring, tape, or a twist tie.
    • Leave the bag around the shower caput for a few hours.
    • Remove the bag and turn on the water for a few minutes to clear the vinegar out of the shower head.
  • If you don't listen removing the caput from the shower piping, you can submerge the shower head in a container full of white vinegar.
    • Permit the shower head soak in the vinegar for a few hours.
    • Re-attach the shower caput to the shower pipe and run water through the head for a few minutes to clear out the vinegar.

#3 Clean the Filter Screen

To clean the filter screen, you may need to consult the shower head pedagogy manual. If you didn't keep the manual, don't panic! You tin unremarkably find it on the website or past contacting the customer service department.

In general, the filter screen is located in the part of the shower head that connects to the pipage. Yous will need to remove the shower caput from the piping to get to the filter screen.

In well-nigh Waterpik® make shower heads, the filter screen can be removed by gently brushing the filter out. Or you can utilize tweezers/needle-olfactory organ pliers to get the screen out of the pivot ball.

Once the filter screen is out of the pivot ball, run the screen under water for a few minutes to flush out any buildup. You tin also utilize a toothbrush to gently brush out mineral deposits.

Identify the filter screen back into the pivot brawl and re-install the shower head to the shower pipage.

Important Note! Harsh cleaning chemicals may harm your shower head and are non recommended for cleaning.


Considering a Replacement Shower Caput?

Replacing a shower head is quick, easy and may reduce your energy and h2o bills.

  • Browse Waterpik Shower Heads

Source: https://www.waterpik.ca/en/shower-head/product-support/articles/top-3-tips-for-cleaning-your-shower-head/

0 Response to "How To Remove Waterpik Head"

Post a Comment

Iklan Atas Artikel

Iklan Tengah Artikel 1

Iklan Tengah Artikel 2

Iklan Bawah Artikel